Could someone enlighten me on how the hole to lead ratios for through
     hole technology was derived in IPC-D-275?

     Specifically, does it;
        consider automated placement or manual insertion?
        consider hand assembly, wave solder, reflow solder, or any?

     Thank you very much, Rich.

     [log in to unmask]  -  NEW ADDRESS!

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################