We are trying to write a Design for Manufacturability assembly and test
specification and were wondering if anyone out there that has been down
this road has any advice for us.  Possibly even sharing your document so
that we can see how it is set up and what it encompasses.
Thanks in advance for your help!
Larry Davis
WGC
Ft. Collins, CO
970-498-3298

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################