Hi technetters , We are considering lamination of heat sink on PCB with Electroless Nickel Immersion Gold ( ENIG ) finishing . What is practical experience with such process ?? Lamination on Nickel should not be a problem , but what about lamination on Immersion Gold?? Regards Edward Szpruch Eltek Ltd - Israel Tel 972 3 9395050 Fax 972 3 9309581 E-mail : [log in to unmask] ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################