Paul,

I thinkyou need to 'fess up and bite the bullet on this one. The board that
you're trying to repair is most likely a multi layer board. While you might
be able to reconstruct the surface traces there is no way to reconnect the
inner layers unless you can get a copy of the artwork of the board. This is
extremely unlikely.

If you were able to snap a PC board in half inside a VCR, you've done more
damage than you think.

Good luck,

Bill Kasprzak
Moog Inc.

PS - That must be some VCR for $1400 bucks, for less than $500 bucks you can
get one heck of a good VCR at most local electronics stores.

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################