> It sounds as if you have an adhesion problem. > Does the residual glue stil have the flat impresasion from the chip? > What type of adhesive is being used? Some are stronger adhesives than > others. > A metal chip has a completely different surface tooth thanthat of a > ceramic chip. > Points to ponder. > > -----Original Message----- > From: [log in to unmask] [SMTP:[log in to unmask]] > Sent: Thursday, May 28, 1998 8:28 AM > To: [log in to unmask] > Subject: [TN] 1206 jumper > > I have a component that is glue cured on the bottom of a pcb. > The > component is a 1206 size jumper. It is made up of iron/nickel > alloy. The > problem I am having is that the part will fall off the board > during wave > solder. Is the component not able to withstand all the heat of > the solder > pot being that it is a solid metal material? Any ideas or > solutions would > be appreciated. > > Rob Williams > [log in to unmask] > > ################################################################ > TechNet E-Mail Forum provided as a free service by IPC using > LISTSERV 1.8c > ################################################################ > To subscribe/unsubscribe, send a message to [log in to unmask] > with following text in the body: > To subscribe: SUBSCRIBE TechNet <your full name> > To unsubscribe: SIGNOFF TechNet > ################################################################ > Please visit IPC web site (http://jefry.ipc.org/forum.htm) for > additional information. > For technical support contact Hugo Scaramuzza at [log in to unmask] > or 847-509-9700 ext.312 > ################################################################ ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################