McGlaughlin, Jeffrey A wrote: > > To All - > > Two questions : > 1- What is the minimum bend radius for a 2 layer Flex board with cover > layer? > 2- What is the minimum distance for placement of components form the > bend line of a flex board? Hi Jeffrey We have some pages on the web that can answer some of your questions. Actually the papers are for rigid-flex boards, but flexboards are similar. Paper about rigid-flex design: http://www.dyconex.com/download/PAPER03.htm general information on rigid-flex and links: http://www.dyconex.com/html/technologies_products/products/rigid_flex_mlb.htm regards Fritz -- _____________________________________________________________________ Fritz Steiner Phone: +41 1 306 35 78 Chief Technology Officer Fax: +41 1 306 36 40 http://www.dyconex.com Email: [log in to unmask] DYCONEX Ltd. Unterwerkstrasse 3 CH-8052 ZURICH Advanced Circuit Technology Switzerland _____________________________________________________________________ ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information. For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311 ################################################################