Isn't the only higher word SHALL? > ---------- > From: Brant R. McClelland[SMTP:[log in to unmask]] > Reply To: TechNet E-Mail Forum.;[log in to unmask] > Sent: Thursday, April 02, 1998 12:47 PM > To: [log in to unmask] > Subject: Re: [TN] MUST > > Hi, > Equate 'must' to 'will be'. > Regards, > Brant McClelland > Design Center, > Solectron Texas > [log in to unmask] > > > > > ---------- > > From: Gabriela Bogdan[SMTP:[log in to unmask]] > > Reply To: TechNet E-Mail Forum.;Gabriela Bogdan > > Sent: Thursday, April 02, 1998 1:28 PM > > To: [log in to unmask] > > Subject: [TN] MUST > > > > Hi,TechNetters! > > I would like to know if and how MUST can be used in order to improve > the > > assembly process.Particulary for NO CLEAN soldering. > > I know the basics of the test.My I hear more? > > Thank you, > > Gaby > ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information. For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311 ################################################################