Hi, Equate 'must' to 'will be'. Regards, Brant McClelland Design Center, Solectron Texas [log in to unmask] > ---------- > From: Gabriela Bogdan[SMTP:[log in to unmask]] > Reply To: TechNet E-Mail Forum.;Gabriela Bogdan > Sent: Thursday, April 02, 1998 1:28 PM > To: [log in to unmask] > Subject: [TN] MUST > > Hi,TechNetters! > I would like to know if and how MUST can be used in order to improve the > assembly process.Particulary for NO CLEAN soldering. > I know the basics of the test.My I hear more? > Thank you, > Gaby > > ################################################################ > TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c > ################################################################ > To subscribe/unsubscribe, send a message to [log in to unmask] with > following text in the body: > To subscribe: SUBSCRIBE TechNet <your full name> > To unsubscribe: SIGNOFF TechNet > ################################################################ > Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional > information. > For the technical support contact Dmitriy Sklyar at [log in to unmask] or > 847-509-9700 ext.311 > ################################################################ > ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information. For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311 ################################################################