Hello Everyone,
I am working on a very small board, such that the vias will actually take up
most of the room.  Could any fab vendors (or anyone else) out there please
let me know of your capabilities in terms of space saved micro via vs.
smallest normally drilled/plated via, and also the cost difference
illustrated between the two.  Thanks so much for your help.
Richard Hatano

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################