Hi,
    I'm working on a board that will be running 23 amps of current thru a
relay.  From the chart, I come up with a trace width of 150 mils using 2 oz.
copper.  They will also be running this board thru a 1000V dielectric test.  I
plan to use a conductor spacing of 120 to 150 mils.  Does this sound right?
These traces are also being run to a connector with pin spacings of 140 mils.
Do you think this will be able to avoid arcing?????
     Need to know ASAP!
Thank You So Much in advance for helping me.

Kitty

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################