Previously I posted a question about the need in the industry for moisture and heat acceleration for curing conformal coatings and interest in how people are currently handling this requirement. I have also heard that in addition to heat and humidity, increased CO2 levels can also accelerate cure times. Does anyone have experiences with coatings with these requirements that they could share? Brian Stumm ETS, LLC [log in to unmask] ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information. For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311 ################################################################