I have a few questions regarding wire wraps for the forum. 1. In order to strengthen a wire wrap connection, is it permissible to solder the post? Where would I find this in IPC? 2. Is it permissible to wire wrap uninsulated wires to posts .1 inch apart? 3. We have dual row Molex headers (pin spacing is .1 in apart). We want to have the ability to jumper to opposite pins. Does someone have a recommendation on how to make the jumper block ruggedized yet flexible (so that jumper selection can be changed at a later time)? Note: The Molex pins have a smaller cross section than standard wire wrap. Thank you, Ellen Berkman Quality Manager, Excalibur Systems [log in to unmask] ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311 ##############################################################