Here's a bit of a different question concerning IPC-D-356 files ,
specifically , paragraph 7.9 soldermask field columns 73-74. This states a
code be used to specify soldermask info. My problem is this ,  the codes
provided can be interpreted in more than one fashion. For instsance code 0
means no soldermask...is that to say no soldermask on that particular feature
, or no soldermask clearance? My understanding is that S3 means slodermask
clearance on both sides of the board , however this could be interpreted
either way leaving it up to individuals rather than relying on a standard.
Could someone please give some insight on this matter? Just thought it was
spelled out in too general of terms.

                                                   Thanks in advance , Chris
Reed

##############################################################
IPC Designers Council Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DESIGNERCOUNCIL <your full name>
To unsubscribe:   SIGNOFF DESIGNERCOUNCIL
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################