We are in the process of designing a circuit board that is approx.
     2 5/8 inches by 11 3/4 inches which is larger than our normal 2/1
     aspect ratio.  The board is an RF board and very busy with components
     very close to the edge, not allowing us to "V" score the board for
     separation from the panel after assembly.  I have seen but never used
     boards that have breakaway tabs that have been drilled to allow for
     ease of separation.  I could use any help or advise.

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TESTNET <your full name>
To unsubscribe:   SIGNOFF TESTNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################