Greetings,

     I have a stripline board construction at 75 ohm.  The DUT has an
     input impedance of 25 ohm.  How can I match the impedances?  Is
     there some circuit to design into the board that I can use to do
     that?  References would be great too.

     Any help would be greatly appreciated.

     Thanks in advance,
     Bilal

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################