We occasionally strip dry film resist off of panels that are printed 
improperly.  We use AlphaMetals PC4046 stripper and water rinse. 
We then send the panels through our Aluminum Oxide scrubber and 
normal dry film processes. The panels are for pattern plate. Is there a 
recommended rework procedure for these mis-printed panels? Is 
water rinse sufficient? The panels yield worse due to shorts than 
normally processed panels.  Any suggestions are appreciated. 

Thanks,

Scott Birnbaum

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]>   *
* with <subject: subscribe/unsubscribe> and no text in the body.          *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact   *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]      *
***************************************************************************