---------- > From: Administrator <[log in to unmask]> > To: Scott B. Westheimer <[log in to unmask]> > Subject: Message not deliverable > Date: Tuesday, May 13, 1997 5:12 AM > > From: Scott Westheimer > Date: 5/13/97 > > I have just recently been put in charge of routing and blanking and I am > encountering several issues. Do most of you out there let/have operators > that change the compensations? Do you have to change them frequently and > over and over again on the same P/N's? Is there software that can help with > fabrication? > > The reasons for my questions is that we have arrays on panels that on one > side of the panels is fine, but on the other end we start cutting into the > fingers. We also have arrays with 3 boards and on the outside cut the board > is 0.020" to wide and the 2 internal boards they are 0.018" to short. Most > of the problems seem to be that when we move away from on edge of the panel > during routing that the dimensions of the routed boards and arrays worsen. > It seem that this has to be compensation because material does not move > that symmetrical. > > Any help would be appreciated. > > *************************************************************************** > * TechNet mail list is provided as a service by IPC using SmartList v3.05 * > *************************************************************************** > * To subscribe/unsubscribe send a message <to: [log in to unmask]> * > * with <subject: subscribe/unsubscribe> and no text in the body. * > *************************************************************************** > * If you are having a problem with the IPC TechNet forum please contact * > * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * > *************************************************************************** *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To subscribe/unsubscribe send a message <to: [log in to unmask]> * * with <subject: subscribe/unsubscribe> and no text in the body. * *************************************************************************** * If you are having a problem with the IPC TechNet forum please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * ***************************************************************************