Hi Technetters: I am investigating an improvement to the ink stamping process used in our facility. We currently mark pwbs with a two part epoxy ink and an oven cure. I was hoping you could offer some information on marking pwbs using UV ink that meets MIL-P-55110 or MIL-STD-130 requirements, or any other process improvement that we could implement. We are a small volume pwb facility and your comments would be appreciated. Thank you Bob Dewlin Modular Components National, Inc. 2302 Industry Court Forest Hill, MD 2150 PH (410) 879-6553 Fax (410) 838-7629 *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To subscribe/unsubscribe send a message <to: [log in to unmask]> * * with <subject: subscribe/unsubscribe> and no text in the body. * *************************************************************************** * If you are having a problem with the IPC TechNet forum please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * ***************************************************************************