Jim.. Thanks for the reply and I will review the 610 spec. However, your last sentence is the crux of my problem.....I DON'T KNOW what should be on the drawing. I was hoping that someone that design/manuf test set hardware could tell me what is acceptable in the real world. Thanks for your imput and I will review the 610 spec. Regards, Bob Bob Vanech Norden Systems (203) 852-4810 *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To subscribe/unsubscribe send a message <to: [log in to unmask]> * * with <subject: subscribe/unsubscribe> and no text in the body. * *************************************************************************** * If you are having a problem with the IPC TechNet forum please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * ***************************************************************************