Hello Gary ! Which operating system do you have ? I have just tried CAMCAD 350 and it works fine, at least with Win 3.11 and NT Which program is using DXF- format ? I use Autocad Lite to read dxf and I have`t had any problems so far. You see, there are many versions of dxf-format, so itīs not sure if this one works in your application. In shareware version ( http://www.ecam.com ) there is no dxf interface ( Win 3.11, 16 bit version ), but you can get it for trial for 2 weeks.You must : 1) Download the program ....exe from ecam.com 2) Extract and install 3)Start program 4)Open file->setup 5)Write down time code and send it to [log in to unmask] by email, asking corresponding access code. DO NOT CLOSE THE WINDOW ! Every time you open the setup window, timed code will change->access code. This may sound complicated, but with this arrangement you will have a chance to try out dxf converter in your application. Good luck ! johannes.sivula@ tellabs.fi Hello Try CAMCAD from www.rsi-inc.com thanks On Thu, 13 Mar 1997, Jeff Foster wrote: > At 08:48 AM 3/11/97 EST, Gary S Thomas wrote: > >Does anyone know of any shareware that will convert Gerber to DXF???? > > > >thanks in advance > > > >gary ... > > Just tried CAM350 from Advanced CAM Technologies ( http://www.ecam.com/ ) > with pretty good luck! > > Their current version (v4.10) has a 7 day timed access period where you can > try all(?) the features. I'm guessing that after the 7 days it reverts to a > crippled version until you have either a dongle (hardware key) or other > access code which you purchase depending upon which level of feature you need. > > > > + - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - + > | Jeff Foster [log in to unmask] | > | Engineering Assistant | > | Broadcast Electronics, Inc. http://www.bdcast.com | > + - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - + > *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To subscribe/unsubscribe send a message <to: [log in to unmask]> * * with <subject: subscribe/unsubscribe> and no text in the body. * *************************************************************************** * If you are having a problem with the IPC TechNet forum please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * ***************************************************************************