Hello I would like to know if fabricating an SMD (double side mount), Six layer PCB, which has a 50 mil pitch pin to pin and 100 mil pitch row to row, 44 pin connector, is possible any where. The drill provided is 30 mil and the pad is 32mil x 80 mil, oblong. Six mil track is routed between the pins. We have had a vendor fabricate this board here in India and due to process tolerances, the yeild is very less or almost has been nil. Information on the fabricators or an alternate solution in pad/track design is very much appreciated. thanks k.varadaraj fm: K.Varadaraj, CADET Automation Systems, India. Ph: 91-80-665 7215, Fax: 91-80-528 0101 email: [log in to unmask] *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To subscribe/unsubscribe send a message <to: [log in to unmask]> * * with <subject: subscribe/unsubscribe> and no text in the body. * *************************************************************************** * If you are having a problem with the IPC TechNet forum please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * ***************************************************************************