Has anyone had any problems with developer antifoams harming panels run through the Black Hole process? I've heard some antifoams have a detrimental effect, either on the surface itself, or on subsequent plating operations. Obviously, poor rinsing would be one cause of this. If anyone has experienced this problem, I'd like to hear about it. Have you found an antifoam that is safe? Or, have you eliminated antifoam in you developer? Any information would be greatly appreciated. Thanks, Mark Dowding Regional Technical Specialist Insulectro 909-943-5758 [log in to unmask] [log in to unmask] *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * *************************************************************************** * If you are having a problem with the IPC TechNet forum please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * ***************************************************************************