From: Stephen Ayotte EM Quality Engineering Bldg. 14-3 Col F5 5-1537 Subject: Fabrication What is the IPC requirements for plated hole diameter due to mfg. defects; plugged holes, etc. Is it 25% reduction, does it depend on whether is has a pin in it or not, which document is it in (IPC-600)? Thanks. **** IBM MD Product Quality Engineer **** **** OEM Quality Engineer **** **** Interenterprise Address: USIB6CEF **** **** Internet Address: [log in to unmask] **** *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * *************************************************************************** * If you are having a problem with the IPC TechNet forum please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * ***************************************************************************