We have been asked what the commercial standards or specifications are for the use of jumpers or connector cuts are in the production of PWBAs. We have already looked at ANSI/J-STD-001B(nothing except for terminal connections), IPC-A-610B (Jumpers), ANSI/IPC-R-700C(Jumpers and Deleting Surface Connectors). Any other suggestions or words of advice in these days of "acquisition reform"? What is acceptable these days where we find procurement of "off-the-shelf" PWBAs with customizing (jumpers, cuts, racing stripes, etc.) so they will perform tthe job. By the way, Class 3 electronics. Regards Doug Whitnell We can be reached at: e-mail: [log in to unmask] Manufacturing Technology Training Center (MTTC), Inc 543 Graaf Street Phone 619 446-5571 Ridgecrest CA 93555 Fax 619 446-4337 Web Site: http://www1.ridgecrest.ca.us/~mttc/mttc.htm We sponsor The 21st Annual Electronics Manufacturing Seminar to be held 19-21 Feb 1997. Contact us for further information. *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * *************************************************************************** * If you are having a problem with the IPC TechNet forum please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * ***************************************************************************