Yes to all of these.
     
        Follow the wave profile for all of your chip components. Caps and 
     ferrite beads will limit your wave profile.
     
        Make sure your spray fluxer and/or foam fluxer can flux the pads. I 
     have seen both shadowed by poor design, mechanical problems, or 
     materials.
     
        Check your dwell time in the wave, especially chip wave. Increased 
     contact time helps.
     
        Check your wave geometry. I have had success with adjusting Hollis 
     exit choke bars, Soltec exit weirs, Hollis front choke bars, and 
     Soltec dross screens.
     
        Please note: +- 5 rpm or 20 pounds of solder in the tank make a 
     difference in yield.
     
        SOTS have been a problem, but are no longer at the top of our yield 
     pareto.
     
     Aric Parr   
        [log in to unmask]

______________________________ Reply Separator _________________________________
Subject: (ASSEM) Wave soldering SOT-23
Author:  [log in to unmask] at internet
Date:    12/10/96 2:02 PM


We are having problems wave soldering SOT's located on the bottom 
side of the boards. The SOT's have insufficient or no solder after 
waving. I have several questions reagarding this problem.
1. Is there a recommended wave profile?
2. Is there a recommended pad geometry for SOT's? 
3. Is there a recommened flux?
4. Does anyone have any reports or technical articles on this issue? 
Thank You,
Tom Rapp
QE
[log in to unmask]
205-582-1800 Ext 1240
     
*************************************************************************** 
* TechNet mail list is provided as a service by IPC using SmartList v3.05 * 
*************************************************************************** 
* To unsubscribe from this list at any time, send a message to:           * 
* [log in to unmask] with <subject: unsubscribe> and no text.        * 
*************************************************************************** 
* If you are having a problem with the IPC TechNet forum please contact   * 
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]      * 
***************************************************************************

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact   *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]      *
***************************************************************************