I am designing a board that has a T0-18 photodiode on it and because of   
the amount of space I have to work with I cannot mount the diode on the   
top of the PCB without it protruding .060 to far through the bezel. I   
need to know if it would be acceptable to put a hole in the board the   
size of the T0-18, slide the diode in from the back, use adhesive around   
it on the top to secure it, and solder the leads to pads on the back of   
the board.  

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************