Jim, I am not certain about IPC, but the ESD Association has developed a fairly comprehensive "Handbook ESD-ADV-2.0-1994" which serves as a good guildeline. ESD Accociation 7902 turin Road, Suite 4 Rome, NY 13440-2069 (315) 339-6937 Best regards, Darrell Drake Sperry-Sun Drilling Service ______________________________ Reply Separator _________________________________ Subject: Does IPC Puplish a standard on ESD Author: [log in to unmask] at Internet-Mail Date: 11/11/96 12:58 PM >Message was resent -- Original recipients were: To: [log in to unmask] -------------- Specifically I am looking for an industrial standard for the packaging and shippment of printed circuit board assemblies to prevent ESD damage in handeling. I looked through your online list and did not se anything. Thank You, Jim Johnson AFP Imaging e-mail [log in to unmask] *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * *************************************************************************** *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * ***************************************************************************