I was given a 300-pin SMD connector from CONNEI that has pin pitch of
0.635mm (0.025")and the pin width of 0.3mm (0.012"). If my board length
is limited to 186mm (7.3") x 140mm (5.5"), how can I get all the
connections up to the rest of the circuitry? Bearing in mind that the
board is heavily populated with LCCs on both sides.

I would appreciate yourhelp as soon as possible. Thanking you, guys out
there in advance! :(

***************************************************************************
*   The mail list is provided as a service by IPC using SmartList v3.05   *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.*
***************************************************************************
* If you are having a problem with the DesignerCouncil, please contact    *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]      *
***************************************************************************