I don't think it's possible to settle this question (though you have surely started a great debate). My $.02 is whatever matters most, card guide, component heights or some combination. As a fabricator, we see it all different ways and wish we could see some standardization (someday). ______________________________ Reply Separator _________________________________ Subject: Multi thickness Author: [log in to unmask] at INTERNET_GATEWAY Date: 1/20/97 10:44 AM Could someone settle a debate? What is the correct measurement of the total thickness of a multilayer board, glass to glass or copper to copper? thanks Mike Gnieski *************************************************************************** * The mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text.* *************************************************************************** * If you are having a problem with the DesignerCouncil, please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * *************************************************************************** *************************************************************************** * The mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text.* *************************************************************************** * If you are having a problem with the DesignerCouncil, please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * ***************************************************************************