Mike: We're using Intergraph Veribest here. We generate a BOM right from the schematic and then place it right on our assy drawing. Larry L. Pucket Dept. 9784 MS0624 Sandia National Laboratories P.O. Box 5800 Albuquerque, NM 87185-0624 Phone: (505)844-1711 Fax: (505)284-3016 Email: [log in to unmask] ---------- From: [log in to unmask] To: [log in to unmask] Subject: BOM's Date: Wednesday, July 17, 1996 10:58AM I am interested to hear what everyone is doing to automate BOM's (Bills of Materials). We use Windows tools and BOM's are (and have always been) a real pain. Is there anything to tie into our MRP system? Ideally I'd like to tie all of our component libraries together with the MRP information with some kind of browser or something...point and click under Windows... am I dreaming?! Any ideas? I would also be interested to hear what other companies are doing to automate this process. Thanks. Mick Donaldson **************************************************************************** * The mail list is provided as a service by IPC using SmartList v3.05 * **************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * **************************************************************************** **************************************************************************** * The mail list is provided as a service by IPC using SmartList v3.05 * **************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * ****************************************************************************