We have established the internal requirements for the volume of the adhesive dispensed onto the PCB. The volume are determined by the diameter of the adhesive dots and its height. These parameters are based on the component package style and design ( pads spacing). For example, for 0805 style components we have 30 mils space between pads. The glue dot diameter is 25mils+/-3 mils with heights of 12 mils +/- 3 mils . Stella Neyman Lectron Products, Ph. 810-608-7289 ------------- Original Text >From C=US/A=INTERNET/DDA=ID/TechNet-request(a)ipc.org, on 7/31/96 12:18 PM: I am looking for information on the aplication of adhesive dots to circuit boards. The dot size needs to be able to accept 0805 parts. If there is anyone out there that has any information on a system with this capability please write. THANK YOU ROB BARNES *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * *************************************************************************** *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * ***************************************************************************