Is it possible for MEK to remove solder mask residues? Someone recently told me this is so, but I'm not so sure. MB ______________________________ Reply Separator _________________________________ Subject: FAB: Use of MEK Author: [log in to unmask] at SMTPLINK-HADCO Date: 7/19/96 08:08 PM Address, A majority of PCB shops out there use MEK (Methyl Ethyl Kentone) in-house. To what extent are most of you using it? Are any of you using MEK to clean rollers on the Resist Laminator or similar? Other than being a health hazard and I'm aware the MEK attacks the rollers. What else? Please advise. John Gulley [log in to unmask] *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * *************************************************************************** *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * ***************************************************************************