Well when I asked the same question six months back no one had a test. Also a
full responce on the whole issue of resist cure was provided by the chairman of
the IPC Solder MAsk committee again no test that works.

DSC did not work for me on wet systems if may work on some dry films.

Bob Willis
Electronic Presentation Services
2 Fourth Avenue, Chelmsford, Essex CM1 4HA. England.
Tel: (44) 01245 351502
Fax: (44) 01245 496123
Home Page: http://ourworld.compuserve.com/homepages/bwillis
Email: [log in to unmask]


***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************