[resubmittal of 3/19/96 message which was not delivered successfully 
     to IPC:]
     
     ======================================================
     IPC TechNet subscribers:
     
     Someone in (printed wiring board) PWB/panel fabrication may be using 
     abrasive water jet cutting. Please see request for information below, 
     which was posted on NIST's TecNet.
     
     -msa
     
     
     ______________________________ Forward Header ________________
     Subject: Abrasive water jet cutting to controlled depth
     Author:  [log in to unmask] at _internet Date:    3/19/96 2:37 PM
     
     
     
     We are working with a client who needs information on the feasibility 
     of using abrasive water jet or abrasive flow machining for cutting and 
     removing material TO A CONTROLLED DEPTH in a calcium carbonate based 
     material. I'm looking for anyone who has experience with these 
     processes or other possible tehnologies for their special application. 
     
     Bob Zider <[log in to unmask]> VMEC, 
     PO Box 500
     Randolph Ctr, VT  05061-0500. 
     Tel: 802-728-1421
     Fax: 802-728-1456.  
     
     --
     Please reply to the sender at the address above.  If you reply by 
     email, please send me a copy. It's a big help if you include the 
     original message with your reply.   Thank you!
     
     Charlie Rosenberg * TECnet * NIST Manufacturing Extension Partnership 
     4 Colby St., Rm 153, Medford, MA  02155
     Tel: (617) 627-3818  Fax: (617) 623-1427  E-Mail: