I would greatly appreciate any help I can get in reference to tombstoning of plastic film caps.  My
pad design for each terminal is .060" X .050". The .060" dimension is for width of the cap.  Each
terminal is centered on the .050", leaving .025" of the pad exposed on each side of the cap. We
have to run the parts perpendicular to the direction of travel through the reflow because it is critical to
the design. Please reply if anyone has experience with this.  Thanks.

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact   *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]      *
***************************************************************************