We are having problems wave soldering SOT's located on the bottom side of the boards. The SOT's have insufficient or no solder after waving. I have several questions reagarding this problem. 1. Is there a recommended wave profile? 2. Is there a recommended pad geometry for SOT's? 3. Is there a recommened flux? 4. Does anyone have any reports or technical articles on this issue? Thank You, Tom Rapp QE [log in to unmask] 205-582-1800 Ext 1240 *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * *************************************************************************** * If you are having a problem with the IPC TechNet forum please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * ***************************************************************************