Frank,
Don't do it!
FR2 and SMT are not a good mix.
I only use FR2 on small thru hole PCBs.
I fear you will have serious yeild problems that would cost considerably more
than FR4 will. FR2 will warp considerably and cause component level problems
after reflow.
FNKEC

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************