Need some help. We have a situation where we would like to document two or possibly more different board assemblies on one panel, that may want to also be produced separately. Each board has its own part number. We have separate numbers for Assy/BOM , fabrication, and Artwork. It seems if the boards are to be produced only in one place there may not be a problem but if there are many vendors used it may be a documentation nightmare. I mean this for the reason that if the boards that are paneled together are ALWAYS needed in the same quantities or that one would never be produced without the other the documentation is somewhat easy. But if one of the boards may want to be produced separately, which could happen. I don't seem to be able to come up with a clean solution that satisfies all departments i.e. purchasing, manufacturing, repair and return, receiving, etc. An example is a CPU card that always has to have a flash memory module on it. We want to fabricate, assemble, and test these two boards together. But they really need to be two separate numbers, and there will be a need to only produce memory modules separately. Any suggestions??? Thanks Bob Wolfe [log in to unmask] *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * ***************************************************************************