Whoa! Steps on artwork sounds like a good idea, but consider this: Steps typically produce partially polymerized resist, that washes off, but does not dissolve in developing. If you have this condition on every panel, the possibility of this resist redepositing in unwanted places becomes a likelihood. I would strongly recommend against this. Mark Dowding Multek, Irvine ______________________________ Reply Separator _________________________________ Subject: Re: Step tablet Author: [log in to unmask] at INTERNET_GATEWAY Date: 10/14/96 10:31 AM -- [ From: Doug Jeffery * EMC.Ver #2.5.1 ] -- Great Idea Otto....Can a dot pattern/half tone pattern work...is it that simple..some one who understands the step tab..let me know...I I never thought of putting it in the film but ..hell ... why not... Doug Jeffery -------- REPLY, Original message follows -------- > Date: Friday, 11-Oct-96 08:21 AM > > From: Otto Jespersen \ Internet: ([log in to unmask]) > To: IPC Technet \ Internet: ([log in to unmask]) > > Subject: Step tablet > > Does anyone know of a way to insert a Stouffer step tablet > as Gerber data on the edge of a plotted file. This would be helpful when > using glass book tools. > > Thank you > Otto Jespersen > Electropac > > ************************************************************************ *** > * TechNet mail list is provided as a service by IPC using SmartList v3 .05 * > ************************************************************************ *** > * To unsubscribe from this list at any time, send a message to: * > * [log in to unmask] with <subject: unsubscribe> and no text. * > ************************************************************************ *** > > -------- REPLY, End of original message -------- *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * *************************************************************************** *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * ***************************************************************************