IPC-RB-276 has test procedure which was written around the bed-of-nails bare-board testers. The test requirement is basically as follows 1. Test continuity and shorts using IPC-ET-652 with the folowing parameters: A. Resistance of any circuit shall not exceed 50 ohms for Class 1, or 20 ohms for class 2 and 3. For lengthy circuits specify what you need. B. Isolation resistance shall be greater than 0.5 megohm for class 1 and 2.0 megohms for class 3. Voltage is selected is sufficient to provide resolution, but if not specified, it is 40 volts. Presently I have received information that these parameters could not be used for flying probe testers. If this is so, I would like some advice on what it should say so that the flying probe could be used per this specification could be used. Thanks Phil Hinton [log in to unmask] 520-745-1013 *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * ***************************************************************************