I'm serving on an in-house Defense Avionics Division Manufacturing Council and am seeking suppliers, vendors, manufacturing representatives, etc. who are willing to address the council. If you are willing to make an informative presentation (20 minutes up to 1 1/2 hr) on your product and/or process to the council, please contact me. Council invitation list for each monthly meetings normally runs around 45 to 50. Respondants names and topics will be submitted to the council chair for consideration upon receipt. Topics the council has expressed interest in, but should not be limited to, include: The use of plastic ICs, BGAs, etc. on military hardware, ESD, Low residue and/or no-clean flux, Conformal coating CCAs after no-clean flux, Transitioning from the Mil-Std-2000A arena to J-STD-001 and/or IPC-A-610, Demand Flow Manufacturing/Just-In-Time methodology, New developments in PWB laminate materials for SMT and/or thru-hole technologies, New developments in semi-automatic part stuffing for thru hole technology. The remaining 1996 Manufacturing Council meetings are scheduled for: Oct. 10, Nov.14 and Dec. 05 but if needed, it may be possible (conference room availablity dependent) to re-schedule one or more of them to fit your schedule. Monthly meetings normally are scheduled from 11:00 to 1:00 or 11:30 to 1:30. !997 monthly council meeting schedule has not been firmed up yet, expect finalization very soon. Honeywell Inc. Defense Avionics Systems Att'n: Pete Phillips NM75-D9 9201 San Mateo Blvd. NE Albuquerque, NM 87113-2227 PHO 505-828-5078 FAX 505-828-5500 E-Mail [log in to unmask] *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * ***************************************************************************