Steve, I only have CDX/VeriBest experience. However when we did see demos about two years ago on both these, Cadence Allegro I believe it was called did have an outstanding auto router. The rest of the software was only ok due to the too many menu/icon picks you needed just to do the simplest of tasks. They may have improved that since. If you purchased or can get a hold of EDIF out for BOTH the PC Board and the Schematic for CDX or Cadence has another plan for conversion you will be dealing with two CAD systems for a long time. If Cadence it turns out that you likeCadence far better than VeriBest and can work out the translater part go for it. The translator for CDX to VeriBest does work well however its not quite push a button you need to make sure of what you have in the CDX design before you translate. VeriBest's best part is the Advanced Editor (very slick), however it does not have all the functionality it should yet but that should not be too far off. We're in the process of evaluating new CAD tools to replace our Intergraph CDX (Cadnetix) systems. I'm in search of feedback from designers with experience on VeriBest PCB and/or Cadence's Prevail Router. Any opinions and/or comments, positive or negative, will be greatly appreciated. Thanks in advance. Steve DiPrizio 508.392.3215 [log in to unmask] We're in the process of evaluating new CAD tools to replace our Intergraph CDX (Cadnetix) systems. I'm in search of feedback from designers with experience on VeriBest PCB and/or Cadence's Prevail Router. Any opinions and/or comments, positive or negative, will be greatly appreciated. Thanks in advance. Steve DiPrizio 508.392.3215 [log in to unmask]