IPC Designers Council, Space Coast Chapter
                                          SUMMARY of minutes for April 9





MEETING OPENED

Opened floor for officer nominations, they were as listed. Please submit any additions prior
to the next meeting when elections will be held. 

THE FLOOR IS OPEN FOR NOMINATIONS!!!

President:                       Greg Goodenbury
Vice Pres/Sec:                   Tom Obarski
Treasurer:                       Mike Holmes

   Appointments
Incorporation officer:           Dave Roberts 
Presentation coordinator:        Chuck Fisher
News Letter editor
Home page edito

################################################################################################
PRESENTATION FOR THE EVENING

Designing with Teflon
speaker, Dave Chapman, Protocircuits

Why Teflon: good dielectric constant control, 2.17 >10.8
                       low loss tangent, 
                       high signal speed.

Tips on designing with Teflon:
                       Don't use solder mask
                       If you do, use only where needed. Also, remember, solder mask sticks
                           better to Copper than to the Teflon. 
                       Add non-platted holes where ever possible to allow for moisture escape.
                      Long baking cycles required to remove moisture.

Sources for further documentation:
                      IPC D 275
                     Rogers Solidine.

MEETING CLOSED.