We have a problem in our Hand Load Area - Not a big problem but a problem. A lot of our assemblies use Hand Loaded - Through hole Resistor Paks. We are constantly getting reversed Resnets (Human error). My question is does anybody have a simple solution to solve our little problem. * 1 Idea was to paint the polarity end to clearly show pin #1. * Another Idea was to place the R-Paks into foam before loading (this idea would work but to time consuming). If anybody has any suggestions or Idea's I would greatly appreciate it. Have a great day Sincerely. ERic Bernal Process Engineer Pragmatech, Sunnyvale, Ca [log in to unmask]