Steve, James, Others: Thanks for your help! I was able to get TH land pattern information from J-STD-001 and the IPC-222x series (successors to IPC-D-275). There's an impressive amount of methods to attach an axial component to a printed board! Best Regards, Stephen Golemme Lead Product Engineer [log in to unmask] 415-779-2475 www.jitx.com ᐧ On Thu, Aug 12, 2021 at 12:18 PM Steve Gregory <[log in to unmask]> wrote: > Hello Stephen, > > J-STD-001 has section about through-hole lead forming that is pretty good. > > > Steve Gregory > > On Thu, Aug 12, 2021 at 10:56 AM Stephen Golemme <[log in to unmask]> > wrote: > >> I'm looking for a standard describing Axial and TH component lead forming >> that described the various options folks can do to prep the components for >> vertical mounting, vibration, different bend points, etc. >> >> I would like a clear language to describe all the options. I've looked at >> IPC-A-610 and IPC-7351, are there other standards? IPC, JEDEC, or >> something >> else? >> >> Thank you!, >> Stephen Golemme >> Lead Product Engineer >> [log in to unmask] >> 415-779-2475 >> www.jitx.com >> >> ᐧ >> > > > -- > Steve Gregory > Kimco Design and Manufacturing > Process Engineer > (208) 322-0500 Ext. -3133 > Cell Phone: (918) 706-2779 > > This email and any attachments are only for use by the intended > recipient(s) and may contain legally privileged, confidential, proprietary > or otherwise private information. Any unauthorized use, reproduction, > dissemination, distribution or other disclosure of the contents of this > e-mail or its attachments is strictly prohibited. If you have received this > email in error, please notify the sender immediately and delete the > original. >