Hehehe...yeah, I seen a few BUTS when I was at RD Circuits, right Guy? Steve On Tue, May 1, 2018, 6:05 PM Dwight Mattix <[log in to unmask]> wrote: > <Engineering canned response #1> > "It depends." > > How thick your board? > What volumes you running? NPI_QTA onshore? Production offshore? > Commodity like super price sensitive pwb fab or high end *BUTS fab? > > dw > > * > Big > Ugly > Thick > Suckers > > > -----Original Message----- > From: TechNet [mailto:[log in to unmask]] On Behalf Of Frank Kimmey > Sent: Tuesday, May 1, 2018 2:55 PM > To: [log in to unmask] > Subject: [TN] Small slots > > How narrow a plated slot can be done without premium? > I realize this is very objective but my bosses want some number. > They won't be satisfied with what my vendor says unless I can back it up > I'm thinking 0.5 mm but would like to know what others think Any help is > appreciated, FNK > > Frank N Kimmey CID+ > Electrical Engineer/PCB Design > > Verifone > 1400 W Stanford Ranch Road > Rocklin, CA 95765 > T: 916-625-1818 > M: 916-833-9877 > > ********************************************************* > This electronic message and any attachments are intended only for the use > of the addressee. The information in this electronic message is > confidential and proprietary, and may include privileged information. If > you are not the intended recipient, please delete this electronic message > and any attachments and notify the sender of the error. Please be aware > that any unauthorized use, dissemination, distribution or copying of this > message or any attachments is strictly prohibited. > -- This email and any attachments are only for use by the intended recipient(s) and may contain legally privileged, confidential, proprietary or otherwise private information. Any unauthorized use, reproduction, dissemination, distribution or other disclosure of the contents of this e-mail or its attachments is strictly prohibited. If you have received this email in error, please notify the sender immediately and delete the original.