LOL. I did live in Canada for 3 years when I was 19,20,21. Worked for Canada Telephone as a lineman, traveling all over the country, coast to coast, repairing phone lines. Lived up northeast of Flin Flon on a Cree Indian reservation. Best three years of my life; I never should have come home. Odin From: BEV CHRISTIAN [mailto:[log in to unmask]] Sent: Thursday, April 26, 2018 7:16 PM To: TechNet E-Mail Forum; Stadem, Richard D Subject: RE: [TN] Flux question đ I see you use âehâ. Part Canuck? Bev Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10 From: Stadem, Richard D<mailto:[log in to unmask]> Sent: Thursday, April 26, 2018 1:19 PM To: [log in to unmask]<mailto:[log in to unmask]> Subject: Re: [TN] Flux question Bev, you anwered at 12:17 my time, and I sent at 12:18 my time. Then I read your response below. Great minds think alike, eh? -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of BEV CHRISTIAN Sent: Thursday, April 26, 2018 12:17 PM To: [log in to unmask]<mailto:[log in to unmask]> Subject: Re: [TN] Flux question Joey, You probably donât want to hear this, but⊠the answer is âit dependsâ. How marginal is marginal? What is the lead finish? Are the pad connected to a ground plane? What is your reflow profile? Regards, Bev Sent from Mail for Windows 10 From: Jose A Rios Sent: Thursday, April 26, 2018 1:06 PM To: [log in to unmask]<mailto:[log in to unmask]> Subject: [TN] Flux question Is ROL0 flux an adequate one when faced with having to solder marginally oxidized components. Or should a different flux type be selected. Application is ground based/hi-rel (non flight). Flowdown is J-001 (not space addendum). ThanksâŠ. JosĂ© (Joey) RĂos, Sr QA Engineer Mission Assurance Manager Kavli Institute for Astrophysics & Space Research Massachusetts Institute of Technology [log in to unmask]<mailto:[log in to unmask]<mailto:[log in to unmask]:[log in to unmask]>> (617)324-6272