There is a form on the next to last page of every single IPC standard........

-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Douglas Pauls
Sent: Thursday, March 08, 2018 7:53 AM
To: [log in to unmask]
Subject: Re: [TN] TM-650-2.1.1; 2.1.1.2 & 2.6.8

Well Victor, if Technet cannot answer your question, your next step would be to pose the question to IPC Staff, such as John Perry, who is very involved with the IPC-6012 and associated board efforts.  He can then direct your questions to the Leadership of A-600 for a response.  That's what this old dinosaur would do....


Doug Pauls
Principal Materials and Process Engineer Rockwell Collins

On Thu, Mar 8, 2018 at 7:49 AM, <[log in to unmask]> wrote:

> Fellow TechNetters:
>
>    I did not receive responses to my initial inquiry.   Therefore, I post
> once again.   IMHO, Industry Standards are so convoluted that it takes a
> dinosaurs to interpret the documents much less draw correlation 
> between the documents.
>
> Victor,
>
> From: Hernandez, Victor G
> Sent: Monday, March 5, 2018 12:37 PM
> To: 'TechNet E-Mail Forum' <[log in to unmask]>
> Cc: Hernandez, Victor G <[log in to unmask]>
> Subject: TM-650-2.1.1; 2.1.1.2 & 2.6.8
>
> Fellow TechNetters:
>
>    What is the purpose of IPC-A-600 (J) if this standard document  is 
> not stated/mentioned/referenced in the above TMs.
>                 2.1.1      section 5.4.3   Quality Observations,
> etc..............
>                 2.1.1.2  section 5.2.3   Evaluation, etc..........
>                 2.6.8      section 5.7.2   Examine for compliance,
> etc.......
>
> Is there a separate document for NEW Laminate Qualification.
>
> Victor,
>