Hey FAB Guys (or Chemical types or anyone else who might help), What should the P content in the Electroless Nickel bath be? I am concerned some of our suppliers are running to high. This could be the cause of some Brittle Fracture failures I have been seeing. What would you consider a good range for Phosphorus percentage in the Electroless Nickel bath? Thanks, FNK Frank N Kimmey CID+ Electrical Engineer / PCB Design VeriFone Inc 1400 W Stanford Ranch Road, Suite 200 Rocklin, CA 95765 USA W: 1-916-625-1818 M: 1-916-833-9877 [log in to unmask] ********************************************************* This electronic message and any attachments are intended only for the use of the addressee. The information in this electronic message is confidential and proprietary, and may include privileged information. If you are not the intended recipient, please delete this electronic message and any attachments and notify the sender of the error. Please be aware that any unauthorized use, dissemination, distribution or copying of this message or any attachments is strictly prohibited.