You nailed it Jerry! Thanks from all of us. -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Jerry Dengler Sent: Monday, October 30, 2017 2:41 PM To: [log in to unmask] Subject: Re: [TN] Plated Through Hole, PTH, annular ring solder wetting with component lead Victor, See IPC-A-610F. Section 7.3.5 Supported Holes - Solder This addresses all of the requirements including "Source Side" and "Destination Side" land area coverage. Jerry -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of [log in to unmask] Sent: Monday, October 30, 2017 3:34 PM To: [log in to unmask] Subject: [TN] Plated Through Hole, PTH, annular ring solder wetting with component lead Fellow TechNetters: Where within the all IPC and other industry Standards can I locate information on PTH annular ring solder wetting on side 1, component side, and side 2 solder side. Does PTH annular ring solder wetting REQUIRED in TODAY"S fast pace assemblies. Victor,.